Danuser 2312 AugerBucket Manual do Utilizador descarregar pdf (Página 16)

STEP 5: Slide the auger away from the motor until the collar clears the shaft.

STEP 6: Pull up and slide the auger toward the motor end of the bucket until the auger is

free of the discharge casing.

STEP 7: Place the auger on a secure work platform. Use a hammer and chisel to remove the

 locknutsfromtheightstobereplaced.

STEP 8: Usingthesuppliedhardware,replacewornrubberightspertheinstructions 

below.

Service

(continued)

Mixing augers require seven sets of hardware per flight, and discharge augers

require four sets of hardware per flight.

NOTE

One disc has been cut down in size. This disc replaces the disc closest to the

motor end of the bucket.

NOTE

1 2 ... 11 12 13 14 15 16 17 18 19 20

Sem comentários

Danuser 2312 AugerBucket Manual do Utilizador Página 16